Search results

Page title matches

• Manual:Cisco VPLS
  ...ion 3.20 RadioOS implements features that provide compatibility with Cisco VPLS features: * Cisco style static VPLS pseudowires (RFC 4447 FEC type 0x80)* Cisco VPLS BGP-based auto-discovery (draft-ietf-l2vpn-signaling-08)
  8 KB (907 words) - 18:36, 26 August 2015

Page text matches

• Manual:VPLS Control Word
  ...''pseudo-wires(PW)''' tunnels over a packet switching network (PSN). Since VPLS encapsulation adds additional overhead, each interface in LSP should be abl ...and checksum (L2MTU) is 1504 bytes. Obviously it is not enough to forward VPLS encapsulated Ethernet frame without fragmentation (at least 1524 L2MTU supp
  3 KB (429 words) - 13:44, 14 December 2015
• Manual:Cisco VPLS
  ...ion 3.20 RadioOS implements features that provide compatibility with Cisco VPLS features: * Cisco style static VPLS pseudowires (RFC 4447 FEC type 0x80)* Cisco VPLS BGP-based auto-discovery (draft-ietf-l2vpn-signaling-08)
  8 KB (907 words) - 18:36, 26 August 2015
• Manual:Interface/VPLS
  Virtual Private Lan Service (VPLS) interface can be considered tunnel interface just like [[M:Interface/EoIP CableFree RadioOS implements following VPLS features:
  10 KB (1,293 words) - 11:40, 26 January 2015
• Manual:EoMPLS vs Cisco
  This article describes the basic setup of Point-to-Point EoMPLS with Cisco routers. In this example IOS 15.1 was used, configuration in older versions [[File:EoMPLS-cisco.png]]
  5 KB (562 words) - 14:36, 14 December 2015
• MPLS Overview
  ** VPLS LDP signaling (RFC 4762) ** VPLS pseudowire fragmentation and reassembly (RFC 4623)
  5 KB (763 words) - 15:27, 26 January 2015
• Manual:MPLS/Overview
  ** VPLS LDP signaling (RFC 4762) ** VPLS pseudowire fragmentation and reassembly (RFC 4623)
  5 KB (765 words) - 18:31, 26 August 2015
• Manual:BGP based VPLS
  ...covers general introduction to VPLS service and configuration of LDP based VPLS tunnels. Due to their static nature LDP based VPLS tunnels have scalability issues that arise when number of VPLSes and sites
  20 KB (2,656 words) - 18:27, 26 August 2015
• Manual:TOC
  **[[Manual:Interface/VPLS | vpls ]] * [[Manual:MPLSVPLS|LDP and LDP based VPLS]]
  17 KB (1,912 words) - 15:20, 22 February 2017
• Manual:MPLS
  **[[Manual:Interface/VPLS | vpls ]] * [[Manual:MPLSVPLS|LDP and LDP based VPLS]]
  8 KB (1,055 words) - 09:19, 13 May 2016
• Manual:MPLS L2VPN vs Juniper
  No configuration currently is needed, later we will bridge VPLS tunnel. /interface vpls
  16 KB (1,637 words) - 14:34, 14 December 2015
• Manual:MPLS/Traffic Eng
  |desc=Defines whether item is ignored or used. By default VPLS interface is disabled. |desc=Defines whether item is ignored or used. By default VPLS interface is disabled.
  9 KB (1,172 words) - 18:34, 26 August 2015
• Manual:MPLS/Traffic-eng
  |desc=Defines whether item is ignored or used. By default VPLS interface is disabled. |desc=Defines whether item is ignored or used. By default VPLS interface is disabled.
  9 KB (1,172 words) - 16:03, 14 December 2015
• Manual:Routing/BGP
  |type=ip {{!}} ipv6 {{!}} l2vpn {{!}} l2vpn-cisco {{!}} vpnv4 |arg=cisco-vpls-nlri-len-fmt
  22 KB (3,172 words) - 18:41, 29 January 2015
• Manual:RadioOS features
  <li>VPLS MP-BGP based autodiscovery and signaling * MNDP - CableFree neighbor discovery protocol, supports CDP (Cisco discovery protocol)
  6 KB (932 words) - 10:41, 26 July 2016
• Manual:Virtual Routing and Forwarding
  ...ces on a single router. This is useful for BGP based MPLS VPNs. Unlike BGP VPLS, which is OSI Layer 2 technology, BGP VRF VPNs work in Layer 3 and as such === PE2 Router (Cisco) ===
  17 KB (2,217 words) - 17:56, 26 August 2015